I just got Meteobridge installed on my RPi4 and I cannot get the system to join my WiFi network.
1) I'm using the specified "Industrial" SD Card from the Meteobridge Wiki (wiki).
2) I flashed the image from the the wiki to the card using BalenaEtcher.
3) I connected it to the network via ethernet and configured via the UI, including the WiFi setting.
4) I disconnected the ethernet cable, restarted the RPi and I see this on the screen instead...
Those last three lines didn't come up on the initial boot and there's more that should take place after that before the software is fully functional so as of now, this system is non-functional. To make that easier to read, they are.
I'm not sure this is the problem, only that this is where the messages stop. Has anyone encountered this and can they help me figure out how to correct it?
I can access the command line by hitting enter at this point, so there's some functionality.
1) I'm using the specified "Industrial" SD Card from the Meteobridge Wiki (wiki).
2) I flashed the image from the the wiki to the card using BalenaEtcher.
3) I connected it to the network via ethernet and configured via the UI, including the WiFi setting.
4) I disconnected the ethernet cable, restarted the RPi and I see this on the screen instead...
Code:
EXT4-fs (mmcblk0p3): Mount option "data=ordered" incompatible with ext2EXT4-fs (mmcblk0p3): recovery completeEXT4-fs (mmcblk0p3): mounted filesystem with ordered data mode. Opts: commit=60,data=ordered,max_batch_time=1000000,min_batch_time=1000000,errors=remount-roI can access the command line by hitting enter at this point, so there's some functionality.
Statistics: Posted by AlphaXrayPapa — Sat Jan 13, 2024 10:50 pm